Iei keypads manual

IEI Wiegand Series Keypad offers multiple keypad styles that support both IEI IM proprietary reader communication protocol for HubMax™ and MiniMax™ panels and standard Wiegand communication protocol. Data 0 IEI Protocol Standard Wiegand Data 1 LED Driver or Door Ajar or Forced Door or Alarm Shunt or Lock IEI PIP's Plug-In Power Supplies. 5. Testing the Keypad After installing the keypad, IEI recommends that you perform the keypad self-test once a year, to ensure that the keypad works prop-erly. 1. To perform the self-test, with the unit powered up, press the following keys on the keypad: #* • If all 12 keypresses are accepted, the keypad enters self-test mode. keypads were evaluated by UL, in Wiegand Front End mode, for use only with the IEI Hub Max II and Hub MiniMax II products used in conjunction with the Wiegand Interface Module. Mounting the Keypad The keypad is designed to be flush mounted using a standard UL Listed single-gang electrical box. Mounting height can vary depending on requirements.

For over 30 years, Linear's IEI brand has built its reputation based on trusted products and responsiveness to customers. With a range of access control solutions, including the market leading Door-Gard stand alone keypad line, Linear offers customers the right solution for their application and combines that solution with a commitment to excellence in service and support. bleshooting a keypad in the field. If you do not get the continuous light or sound then the memory has been corrupt and should be re-programmed with the 46 command (see option #16). 5. Enter the master code of *. The relay will energize. Refer to programming section to program your keypad. NOTE: The keypad may be programmed in your shop or. IEI e Standalone TM Keypad Installation/ Programming Manual Contents Section 1: Features and Product Description Features Product Description Section 2: Specifications Section 3: Mounting Section 4: Wiring Wire Harness Configuration Wiring the e Keypad to a Maglock (Fail-Safe) Wiring the e Keypad to an Electric Strike (Fail-Secure) Shunting a Normally Closed.

interfering with the operation of the keypad, ground the negative terminal of the keypad to earth ground. If you cannot ground the power supply, then you must ground the keypad housing. IEI recommends using a filtered and regulated power supply When mounting the w outside, use a weatherproof back box and apply silicone to the area where the. keypads were evaluated by UL, in Wiegand Front End mode, for use only with the IEI Hub Max II and Hub MiniMax II products used in conjunction with the Wiegand Interface Module. Mounting the Keypad The keypad is designed to be flush mounted using a standard UL Listed single-gang electrical box. Mounting height can vary depending on requirements. keypads. Interfaces with any parallel printer for user/door activity logging INSTALLATION • IEI WEATHERPROOF SURFACE BACK BOX • IEI FLUSH MOUNT BACK BOX • IEI 12 or 24 VDC 1A PLUG-IN POWER SUPPLIES • IEI THREE RELAY PLUG--IN BOARD with FORM C, 1 Amp relays. Converts transistor outputs to dry contacts.